4 zone fire alarm control panel

The fire alarm control panels (4 Zones, 8 Zones, and 16 Zones) provide all of the sophisticated features required of a leading edge conventional fire alarm system along
with the simple operation and efficient installation methods demanded by both
installers and building users.

The panel can be flush or surface mounted and the generously sized metal back box allows ample space for rear or top cable entries.
A comprehensive range of auxiliary devices is available to operate with the fire control panels including optical, ionization, photoelectric, and heat detectors.
Each of the system components has been specifically designed to operate as part of the system. This provides assurance that the control panel, smoke detectors,interface devices and the ancillary components are all fully compatible with one another and that the full range of system functionality is supported by each device.
Installation manual can be downloaded at alarm system support

1.1 Product features
The panels have the following key features:
4, 8, or 16 conventional input zones.
2 notification appliance circuits (NAC, Sounder) with built-in
synchronization forANSI 3.41and Gentex.
The panel comes with a 3 amp power supply.
Dedicated alarm and fault relays.
1 RS485 can be able to connect repeaters.
Enclosure supports two 12V, 7Ah backup batteries.
1.2 Electrical specifications

Primary AC 200 to 240VAC 50/60 Hz
Standby current: 50mA@220VAC,Alarm current: 85mA@220VAC
Power supply rating 3Amps @ 24VDC
Maximum Battery Charging Current 0.98 Amps @ 26VDC
Initiating Device Circuits 4 Zones Alarm Zone 1, 2, 3, & 4
Initiating Device Circuits 8 Zones Alarm Zone 1, 2, 3, 4, 5, 6, 7, & 8
Initiating Device Circuits 16 Zones Alarm Zone 1, 2, 3, 4, 5, 6, 7, 8,9,10,11,12,13,14,15, &16
Normal Initiating Operating Voltage 23VDC, Maximum 26VDC, regulated
Short Circuit Initiating Current (per zone) 35mA Maximum
Maximum Initiating Resistance (per zone) 10 ohms
Initiating End-of-Line Resistor 4K7 ohms, 1/2W 5%
Standby Detector Current (per zone) 4mA maximum
Maximum Detector Count (per zone) 30 detectors
Initiating Cabling Type 18AWG Twisted Shielded pair (14 – 18 AWG)
Detector Base Impedance 430 ohms
Notification Appliance Circuits(Sounder) 2 NACs, SpecialApplication
Maximum NAC Current Rating 1Amp maximum per circuit
NAC End-of-line Resistor 10K ohms 1/2W 5%
FAULT Relay rating 2A& 30VAC, resistive
Alarm(Auxiliary ) Relay rating 2A& 30VAC, resistive
Enclosure Dimensions 353mm(L)×282mm(H)×101mm(W)
Net Weight 3.1kg (Without batteries)